Leviton 734685

5G270-U48

QUICKPORT PANEL 48P MAKE OFFER

PATCH PANEL

NEW IN BOX SURPLUS

Patch Panel 48 Port preloaded with Gigamax 5 E connectors Cat 5 E

Leviton
49005-CMB

Cable Management Bar

MAKE OFFER

bar

NEW IN BOX SURPLUS

 

Watts Electric
Actuation and Control
PF400

PF400-11A-B

4-20MA VALVE CONTROL 400 IN/LB

MAKE OFFER

PF400

  • NEW SURPLUS
Designed with the two most important
electric actuator requirements in mind
— POWER and FLEXIBILITY.
At Watts, we pride ourselves on keeping up with the demands of the marketplace, and meeting those demands with innovative product development. The PF Series is no exception. With the Power-Flex electric actuator, we have developed a versatile unit that packs the power required for your specific application.
This rugged electric actuator is designed to outlast and
outperform similar designs. Our split phase, reversing motor, coupled with an efficient spur gear design, produces torques of 400, 700, 1100 and 2000 in./lbs., with a standard extended duty cycle motor. The unique combination NEMA IV, VII and IX enclosure is suitable for both weatherproof and hazardous environments- simultaneously. The heavy-duty male output shaft ensures positive valve cycling without fear of shaft fatigue over time. Additional features include a declutchable manual override, a highly visible position indicator beacon, and corrosion resistant epoxy coating - all examples of Watts’ continued philosophy of offering more features as standard at no extra cost.
The PF Series can be tailored to your application requirements
by incorporating such options as: additional auxiliary SPDT limit
switches, heater/thermostat, 0-1000 OHM feedback potentiometer,
cycle length modules, 4-20 mA control board, and fail safe
battery pack. Power voltages 115 VAC, 230 VAC, single phase,
12 and 24 VAC, 12 and 24 VDC.

CUTLER HAMMER

E56CDL40A2

20-250 VAC

Catalog Number
E56CDL40A2

Min. Separation mm [in.]10 [0.39]

E56CDL40A2

NEW IN BOX SURPLUS

INTRODUCTION
Type E56 AC “Pancake” Inductive Proximity Sensors are 2
wire solid state switches that respond when a metal target
enters its sensing field. These sensors have a NO (normally
open) or NC (normally closed) switching configuration.
Each sensor has a 1/2 inch conduit entrance for field wiring
and has a built-in LED indicator that becomes lit when a
target is detected.
Made of reinforced polyester, each model is gasketed for
NEMA 4, 6, 11, 12 and 13 enclosure ratings.
TO PREVENT INTERNAL DAMAGE TO THE SENSOR, AVOID ANY
SHORT ACROSS THE LOAD.
       
       
       
       
       
       
       
       
       
       
       
       
       
       
       
       
Competitor SiteCompetitor Site Information